What does no bus mean on my Dodge Durango?

The no bus signal indicates the computer (PCM) has lost communication with its components. Wiring harness to the PCM to make sure nothing is loose or damaged. Let me know what you find.

What does no bus mean on a Dodge?

” No Bus ” means the CCD communication bus is down.

What does no bus mean on a 2000 Dodge Dakota?

The no bus means there is a loss of communication between the computer and its components. Check the wiring harness to the PCM and make sure it is tight, and not corroded. Also, check wiring for any damage.

What does no bus mean on a 2001 Dodge Dakota?

No Bus means no communication from the ECU to the instrument cluster. You must have disconnected something.

How do you reset the security system on a 1999 Dodge Durango?

Turn the ignition switch to “ON” without starting the engine. Press and hold the valet/override button below the steering column within five seconds of turning the ignition on. Release the valet/override button when the security light on the instrument panel stops blinking. The alarm is reset and disabled.

You might be interested:  Readers ask: Which Way Is The School Bus Facing?

What does no bus mean on a 2005 Dodge Stratus?

” NO BUS ” means the dash isn’t getting a signal from the engine or body computers.

What does no bus mean on Chrysler?

” No Bus ” means the data cable going to the (PCM) computer is unplugged, or the PCM has failed and not able to read the information it is being given. Sometimes just jiggling the PCM causes the ODO ” NO BUS ” to come on. Sometimes a bad crank or cam sensor can cause this as well.

What does no bus mean on a Jeep Patriot?

” no bus ” usually indicates a loss of communication between the various modules (computers) on the car.

What does no bus mean on a Jeep Cherokee?

A no bus appears on the dash and the engine does NOT run. This is your problem. A good majority of times, it is a failed (shorted) crankshaft position sensor causing this. Theoretically, any 5 volt engine management sensor can short and cause this problem, but the crank sensor is the most suspect.

What does no bus mean on my Dodge Dakota?

If You see a no bus error message on the instrument cluster in Your Dodge Dakota that means that Your gauge cluster has lost communication with the ECU. The ECU communicates with instrument cluster via a system that is called CAN BUS.

How do you reset the computer on a 2004 Dodge Dakota?

1) Disconnect NEG Battery Terminal. 2) Turn the ignition key to the START position and hold for 15-20 seconds. 3) Release key (OFF) and reconnect the battery.

Leave a Reply

Your email address will not be published. Required fields are marked *